STM32F100 discovery demo

Write here to receive support strictly related to the code of our demos.
Forum rules
  • Ask only about PLAY Embedded related stuff.
  • Use English only.
  • Have common sense.
  • Spamming is not permitted, please keep all your posts as constructive as possible.
  • Here we provide support on our code only. An off-topic request will be locked and user warned.
Post Reply
misterno
Posts: 1
Joined: Wed Jul 03, 2019 9:59 am

STM32F100 discovery demo

Post by misterno » Fri Jul 05, 2019 5:42 pm

Hi all,

I have a problem with chibistudio, i don't know how to handle it and i want your help.
The board i 'm trying to test is the STM32FVLD discovery.
This kit is working well only with ST-link utility so far.

I 'me trying to run the demo and i get the following error:

Open On-Chip Debugger 0.10.0+dev-00226-g1c2e3d41d (2017-12-23-10:15)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Warn : Interface already configured, ignoring
Error: already specified hl_layout stlink
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
none separate
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : clock speed 950 kHz
Error: libusb_open() failed with LIBUSB_ERROR_NOT_SUPPORTED
Error: open failed
in procedure 'init'
in procedure 'ocd_bouncer'

Any help will be appreciated
TIA

User avatar
guglielmir
Founder
Posts: 22
Joined: Mon May 09, 2016 1:47 pm
Location: Salerno Area, Italy
Contact:

Re: STM32F100 discovery demo

Post by guglielmir » Fri Jul 05, 2019 7:09 pm

Ciao Misterno,
this forum is intended to provide support about topic related to our articles while your question seems more related to ChibiStudio.

Said that, I suggest you to try to connect to the debugger through the STLink Utility to be sure your drivers have been installed properly and that HW is working appropriately.
Ciao,
RoccoMarco

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests